The roadway expansion transformed SH 105 from two lanes to four at the FM1774 crossing.
During excavation, natural springs were uncovered in the westbound lane, saturating the subgrade
The saturated subgrade consisted of expansive clay soils with a very low CBR of 1.5%.
Cement stabilization was originally planned but deemed unsuitable under high moisture conditions.
MIRAFI® H2Ri geosynthetic was installed to provide both reinforcement and active moisture management.
Reducing land take and carbon footprints with reinforced soil slopes
A reinforced soil slope system helps optimize land use in industrial estate expansion in Thailand. With 20,000 m² of MIRAGRID, the project created stable embankments, reduced constructions costs and maximized available land for future use.
Dredging the Schwarze Elster River with GEOTUBE
Discover how GEOTUBE® dewatering systems helped manage 10,000 m³ of sediment from the Schwarze Elster River, delivering an effective dewatering, containment and cost-effective solution.
Managing subsurface moisture at Missouri River bridge with MIRAFI
MIRAFI® H2Ri was incorporated into Missouri River bridge approaches to manage subsurface moisture, replace a drainable aggregate layer, and reduce aggregate requirements while supporting pavement construction.
The widening of State Highway 105 at the FM1774 crossing in Plantersville, Texas, presented both construction and long-term performance challenges. The project involved expanding the existing east-west, two-lane roadway into a four-lane roadway.
During earthwork, cuts into the natural hillside revealed the presence of springs in the westbound portion of the project. This led to increased moisture content, bringing the subgrade to a nearly saturated state and creating challenging conditions for construction. The observed cracking was likely caused by the roadway being built over moisture-sensitive soils, specifically expansive clays, combined with fluctuating groundwater levels and capillary action.
The original pavement design for the project included cement-stabilized subgrade to treat the existing soil, which had a California Bearing Ratio (CBR) of 1.5%. Additionally, the pavement section incorporated seven inches of flex base and eight inches of asphalt. However, the project team recognized that cement stabilization of the subgrade under saturated conditions would be problematic. As a result, they sought alternative solutions for subgrade stabilization and moisture management.
To address the subgrade challenges, the project team reinforced the pavement section using MIRAFI® H2Ri, a high-strength geosynthetic engineered to manage moisture. This solution allowed the team to eliminate the need for cement stabilization while maintaining the original pavement thickness.
The Texas Department of Transportation (TxDOT) had previously used MIRAFI H2Ri in a test installation and was able to apply the same solution for this project. The use of MIRAFI H2Ri provided both mechanical stabilization and active moisture management, ensuring long-term pavement performance despite the challenging soil conditions. The roadway has shown no signs of distress since construction in 2020.
To learn more about how geosynthetics outperform chemical stabilization in roadway applications, click here.